Pull Down Menus; File Pull Down Menu - Open - Navitar 12X Zoom Instruction Manual

Navitar Motorized Zoom Systems Instruction Manual for Windows
establish the communications, the PC's bell will sound indicating communications
failure and the indicator will remain blank.
To establish communication manually, click the "Mode" pull down menu and
select "connection". A small dialog box opens:
Open the list of possible COM ports or USB devices by clicking the down arrow
next to list. Select the correct communications port from the list by clicking it and
confirm the selection by clicking the OK button.
The Off line selection is used for parameter set up and testing. The computer will
not attempt to establish the communications connection with the controller. The
user can change all parameters, but the controller will not operate until
communications is established.
If the communications is not established after the correct port is selected, check
the following:
Power to the controller is turned on.
Cable is connected to both devices.
Correct cable is being used. The 'Null' modem cable will not function.
Serial port is enabled within the PC environment.
Consult with your system administrator to get help establishing
communications.
To go "off-line" again, select "connection" from the "Mode" line and click off-line in
the selections.
8

Pull Down Menus

8.1

File Pull Down Menu - Open

The File pull down menu is used to load or save different set-ups of the control
panel. This feature is used to save and reload a particular configuration of
motions. The values saved and reloaded are the set points; minimum and
maximum jog values and the dwell time. Values for both motors are saved and
reloaded. Note that this feature does not save the values entered in the
customer set-up chart such as acceleration curves, velocity, etc. These must be
re-entered depending upon the application.
Revision B Page 8 of 23 2/17/2004