Introduction; Setting Up - Serial Port; Setting Up - Usb Port; Installation - Navitar 12X Zoom Instruction Manual

Navitar Motorized Zoom Systems Instruction Manual for Windows
1 Introduction/Precautions
This controller/driver application allows the user to configure and control a 1 or 2
motor zoom/focus system complete with limit sensors. The system may be
connected via serial or USB communication; however, both methods shall not be
connected simultaneously. Additionally, the zoom/focus motor cables shall never
be connected or disconnected while the controller is under power. This will cause
damage to the controller!
2

Setting Up - Serial Port

Connect the controller to the serial port on the PC (9 pin serial cable). Note the
COM number. On most PCs with only one serial port, the port is COM1. Some
older PCs have multiple COM ports. Usually these ports are labeled.
Connect the power pack to AC wall outlet and to the controller.
Connect both the zoom and focus (where applicable) 15 pin cables to the
controller.
3

Setting Up - USB Port

Connect the USB cable between the PC and the controller.
Connect the power pack to AC wall outlet and to the controller
Connect both the zoom and focus (where applicable) 15 pin cables to the
controller.
4

Installation

Windows:
Locate the following file and open by double-clicking.
Following the steps will produce the following icon on the desktop.
Navser.lnk
USB:
Locate the following file and open by double clicking.
Revision B Page 5 of 23 2/17/2004