Advertisement
SIM2
INSTALLATION MANUAL
Introduction
The SIM2 Sensor Integration Module is designed to provide
dry contact closure or 12 VDC output in response to input
®
status from ELAN
SENSE Automation Sensors in home
automation applications. Capable of being used as a
stand-alone device, the SIM2 integrates four sensor inputs
with two relay outputs and provides simple setup and
operation with no programming required. Relays respond
to sensor triggers differently based on conditional logic DIP
switch settings.
Features
• Stand-Alone Interface for ELANSENSE Automation
Sensors
• Any ELANSENSE Sensor Can Trigger Either Of Two
On-board Relays
• All Four Sense Inputs Can Be Linked To One Relay
• Conditional Logic AND/OR Settings
• Simple Setup & Operation-No Software Required
Specifi cations
Sense Inputs (x4) .............................................. 3.5mm Stereo Mini Plug
Relay Outputs (x2) ............................................ 8 pin WECO Connection
Rated Load ................................................ .5A @ 120VAC or 1A @ 24VDC
Power Output ................................................................. 12VDC @ 650ma
Power Requirements .................................................... 12VDC 2.1 Amps
Mounting ........................ Adhesive Strip and Mounting Screws Included
Page 2
ELAN HOME SYSTEMS
NO, NC, COM, GND,12VDC
Accepts 24 AWG (Cat-5) Wire
PWR3 Power Supply Included
© ELAN Home Systems 2006 • All rights reserved.
Advertisement
