Select Intensity And Start Session; Turn Off; Change The Wristband - Weber EndoLight User Manual

Recover: Activates all diodes simultaneously
#
Graphic 12-14: Modes
Press the button to "scroll" through the modes. Confirm your selection with On/Off.

Select intensity and start session

Set intensity via the rocker switch. You can choose from the following intensity levels:
25 % 50 % 75 %
Graphic 15: Intensity
The button increases the intensity. The
your selection and start the session.
The selection applies to all diodes simultaneously. Individual diodes cannot be selected separately.

Turn off

After 30 minutes the EndoLight® beeps three times before turning off automatically. Alternatively, you
can end the session early by pressing and holding the On/Off button.
If the contact sensor is not near the skin, the diodes will not turn on, or stop if already
on. The timer will pause, and this screen will show up together with an acoustic signal.
Please correct the fit on your wrist to start or continue the session.
Graphic 16: Notice Contact sensor

Change the wristband

You do not need any tools to replace the wristband.
Detach the wristband
Both parts of the wristband have a small spring lock that secures the band to the device. To mount the
smaller wristband, you only need to detach the part with the holes.
Slide the silver spring pin of the band down to release it. You can use your finger or a pointed object.
100 %
button decreases it. Press the On/Off button to confirm
13