Setting Up; Prepare Vehicle And Battery; Check Battery Compatibility - VOLTCRAFT VC-BT100 Operating Instructions Manual

10 Setting up

10.1 Prepare vehicle and battery

1. Switch accessory loads OFF (e.g. air conditions, lights, radio).
2. Disconnect / switch OFF items connected to auxiliary power outlets (e.g. GPS,
cameras).
3. Remove the key from the ignition.
4. Close all doors.
5. Allow vehicle parts to completely cool down.
6. Make sure battery terminals are clean.
7. If the battery has just been fully charged, switch the vehicle headlights ON for
approximately 3 minutes to allow the battery voltage to drop to normal value.

10.2 Check battery compatibility

The product will test each battery according to the selected system standard and
rating marked on the battery.
Check the battery type and CCA (cold cranking ampere) values marked on the
battery label.
Check if the battery type is supported by this product. See section: Technical
data.
30