BlueParrott B250-XTS Quick-start Guide

CHARGE HEADSET FULLY PRIOR TO FIRST USE

Package Contents

1. B250-XTS™ Headset
2. Spare Foam Ear Cushion
3. Spare Microphone Windscreen
4. USB Charging Cable
5. Quick-Start Guide
6. Warranty and Compliance Insert

Features and Functions

1. Multifunction Button (MFB)
2. Indicator Lights
3. Volume Up/Mute
4. Volume Down
5. Flexible Microphone Boom ("Talk" side towards mouth)

IMPORTANT SAFETY NOTE: Prolonged exposure to high volume levels can damage your hearing. To avoid injury, set the volume to the lowest comfortable level. If you experience ringing in your ears, or voices sound muffled, stop using the headset. Avoid turning up the volume to block noisy surroundings. Your ears may adapt to volume that is too high, which could result in permanent hearing damage without any noticeable discomfort.

Wearing and Adjusting the B250-XTS

For best noise-canceling performance, position the microphone towards the corner of your mouth. Positioning is important; small adjustments in microphone placement can improve performance.

1. Place the headset on your head.
2. Position the speaker directly over your ear by sliding the headband in or out of the side support.
3. Align the "Talk" side of the microphone toward your face.
4. Position the microphone at the corner of your mouth—about one finger's width away from your face.
5. To adjust the headband tension, flex it outward to loosen or inward to tighten.
   

Charging

Connect the USB charging cord to the headset. The headset LED will glow red when charging and green when fully charged.

Power B250-XTS On/Off

On: Hold down the MFB for 2-3 seconds, until you hear a voice prompt, "Power On." The blue light will quickly flash three times as the headset turns on.

Off: Hold down the MFB for 3-4 seconds, until you hear a voice prompt, "Power Off." A red light will flash 4 times and the headset will turn off.

Manual Pairing

Placing Headset into Pairing Mode: With the headset powered off, press and hold the MFB. You will hear the voice prompt "Power On". Keep holding the MFB for approximately 10 seconds, until you hear "Discovering". Indicator lights will alternately flash between red and blue. Headset will be visible for pairing to devices for 120 seconds.

Pairing to a Cell Phone:

1. Make sure that other Bluetooth devices are turned off or out of range.
2. Place headset into pairing mode.
3. Put your cell phone in Bluetooth Search/Scan Mode per the manufacturer's instructions.
4. Select "BlueParrott B250-XTS" to pair. (Passcode is "0000" if needed.)
5. When connected, the headset will give you the voice prompt, "Your headset is connected".

Multi-Point Mode

In multi-point mode, the headset can be simultaneously paired and connected to two cell phones. The headset will allow you to switch between phones when there is an incoming call. Multipoint needs to be enabled on the headset to do this. See the full user guide for more information.

Quick-Reference Tables

Multiple Device Pairing and Advanced Features

The BlueParrott B250-XTS can pair with up to eight (8) devices. However, only two (2) devices may be connected to the headset at one time (Multi-Point). For more information on advanced features, please refer to the complete user guide, available online.

For the full user guide, technical notes, and available accessories, go to blueparrott.com.

BlueParrott | 900 Chelmsford Street, Tower II, 8th Floor | Lowell, MA 01851
Toll-Free (USA): 800-742-8588 | Phone: +1 603-742-2888 | blueparrott.com
© 2018 GN Audio A/S. All rights reserved. APN 203895D 02/18