Standby Mode: Headset is on, Bluetooth link is active, and the user is not on a call (blue light will flash) . Talk Mode: Headset is in use with the cell phone while the cell phone is on an active call (blue light will flash) . BlueParrott B250-XT User Guide PAGE 4...
2 .5 hours to achieve a complete charge . BATTERY POWER INDICATORS While charging, the MFB’s indicator light shows the level of battery power on your B250-XT as follows: Green light: Fully charged . Over 16 hours’ talk time . Red light: Less than a full charge .
OPERATION WHILE USING THE CHARGER The B250-XT headset will operate from battery power or from a USB power source . NOTE: Do not attach the USB cable mid-call. This will cause the headset to reset and the call will be sent back to the phone.
Volume Up/Mute button for 2 seconds until you hear a beep . A mute reminder will be heard every 10 seconds . Repeat button press to unmute . BlueParrott B250-XT User Guide PAGE 8...
• Put your cell phone in Bluetooth Search/Scan Mode per the manufacturer’s instructions . • Select “BlueParrott B250-XT USB” to pair . (Passcode is “0000” if needed .) • When connected, you will hear a single tone and the indicator light will be flashing blue .
WEARING AND ADJUSTING THE B250-XT • Place the headset on your head . • Position the speaker directly on your ear . You can slide the headband in or out of the side support for proper fit . • Position the microphone about one finger’s width away from your face at the corner of your mouth .
Rejecting an Incoming Call • To reject an incoming call, press and hold the MFB for two seconds . You will hear two descending tones and the call will be transferred to your voicemail (if available) . BlueParrott B250-XT User Guide PAGE 11...
ADVANCED FEATURES AND FUNCTIONS Multiple Device Pairing The B250-XT can pair with up to 8 devices; however, only one device may be connected to the headset at a time . Once all devices are paired, connection to the last paired device can be made by turning the headset off and then on again, or with a quick press of the MFB .
6-10 seconds until two low tones are heard . • Power off the headset . The pairing memory is now clear and will need to be paired to any desired devices before it can be used with them . BlueParrott B250-XT User Guide PAGE 13...
Start Proximity Pairing MFB & Volume Down Alternating red and blue Long low tone every 5 (quick press) flash seconds for 60 seconds Proximity Pairing Timeout None None 2 short tones (after 60 seconds) BlueParrott B250-XT User Guide PAGE 14...
Page 15
Incoming Call Hold NONE NONE (2 quick presses) Accept Held Incoming Call MFB NONE NONE (quick press) Reject Held Incoming Call NONE 2 falling tones (1-2 seconds) *Sends call to voicemail (if available) BlueParrott B250-XT User Guide PAGE 15...
Page 16
Red light, slow flash 1 short tone (Link Loss) Low Battery NONE Red light, 2 fast flashes NONE Connect A2DP NONE Blue MFB NONE (quick, double-flash) Proximity Pairing Timeout NONE NONE 2 short tones (after 60 seconds) BlueParrott B250-XT User Guide PAGE 16...
Need help?
Do you have a question about the B250-XT and is the answer not in the manual?
Questions and answers