Eve TF-20 X Table of Contents 1. Before You Begin ............... What Is Included ................... Unpacking Instructions.................. Claims ..........................Text Conventions ..................Symbols ......................Disclaimer ..................... Intellectual Property ..................Safety Notes....................2. Introduction ................Product Overview..................Product Dimensions ..................3. Setup ................... AC Power ......................
Before You Begin 1. Before You Begin What Is Included • Eve TF-20 X • Gel frame • Track adapter • Quick Reference Guide • Barn doors Unpacking Instructions Carefully unpack the product immediately and check the container to make sure all the parts are in the package and are in good condition.
Before You Begin Safety Notes ■ ALWAYS: ♦ Connect to a grounded circuit. ♦ Connect to operating voltages as specified on the product's spec sticker. ♦ Disconnect from power before replacing the fuse. ♦ Disconnect from its power source during periods of inactivity. ♦...
Introduction 2. Introduction Product Overview Barn door Power cable attachment clip Mounting hole Barn doors Product Dimensions 4.8 in 3.4 in 123 mm 87.8 mm 7.9 in 201.5 mm Eve TF-20 X User Manual Rev. 1...
Setup 3. Setup AC Power The Eve TF-20 X has a fixed voltage power supply, and it can work with an input voltage range of either 120 VAC, 60 Hz or 220 VAC, 50 Hz, depending on the specific model. To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart.
Setup Track Adapter Before mounting this product, read the Safety Notes. To splice the included Track Adapter onto the Eve TF-20 X : Cut the power cable, leaving 1.5 feet for maneuverability. Strip enough of the cable and wires to allow for splicing. Dismantle the Track Adapter: 120 VAC Remove...
Page 8
Setup Splice to the Track Adapter as shown in the diagram below. 120 VAC 220 VAC Splice Wires Splice Wires (with included wire nuts) (with screws) Ground Neutral Neutral Ground Live Live Secure the Track Adapter to the mounting bracket using the hollow bolt and nut(s), and reassemble it.
Setup Mounting Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes. Orientation The Eve TF-20 X may be mounted in any position; however, make sure adequate ventilation is provided around the product. Rigging • Before deciding on a location for the product, always make sure there is easy access to the product for maintenance and programming purposes.
Maintenance 4. Maintenance Product Maintenance Dust build-up reduces light output performance and can cause overheating. This can lead to reduction of the light source’s life and/or mechanical wear. To maintain optimum performance and minimize wear, clean your lighting products at least twice a month. However, be aware that usage and environmental conditions could be contributing factors to increase the cleaning frequency.
Technical Specifications 5. Technical Specifications Dimensions and Weight Length Width Height Weight 7.9 in (201.5 mm) 4.8 in (123 mm) 3.4 in (87.8 mm) 2 lb (0.9 kg) Note: Dimensions in inches rounded to the nearest hundredth. Power Power Supply Type Range Voltage Selection 120 VAC, 60 Hz...