Cleaning And Maintenance - Hisense SC-242 User's Operation Manual

Placing items in the Showcase
This showcase employs a forced circulation of cold air system. If circulation of
cold air is obstructed, the items will not be adequately refrigerated. Pay
attention to the following points:
Do not let items obstruct the cold air inlet and suction outlet.
Place items so that they do not protrude from the shelves. The gap between the
shelves and the door is used for circulation of cold air.
Place items evenly on all shelves.
Do not display goods on the bottom. Put the goods on the shelf.
Product lighting
This appliance has a switch that turns
on/off the light on the top display and
interior of the product. The switch is
located on the bottom of the display
Replacing the lamp
When you need to replace the lamp,
follow these instructions:
1. Remove the plug from the outlet
2. Unscrew the screws that fix the
display panel.
3. Remove the display panel
4. Remove the lamp by turning it
counterclockwise, which is like the
lamp unscrewed to exit.
5. Replace the burned lamp by another
with the same power rating and
dimensions.
6. Replace the display panel
25
Unscrew the screws of
the display panel
Remove the display panel
Replace the
burned lamp
Replace the display panel

Cleaning and maintenance

Exterior and ShowCase compartment
Wipe with a soft and dry cloth. If is very soiled, wipe with a cloth that has been
moistened with a detergent. Then wipe with cloth that has been dipped in water.
Clean the Showcase regularly to keep it clean all the times.
Never use polishing powder, soap powder, benzine, oil or hot water as these
will damage the painting and the plastic components.
Attention
To prevent any electrical shock hazards or injury by rotating circulation fan,
always disconnect the power cord plug from the wall outlet before cleaning.
Do not splash water directly into the Showcase and do not wash with water . This
can result in a short-circuit and electrical shock.
Checks
To ensure the safety, perform the following checks after cleaning.
Is the power cord plug firmly inserted into a dedicated wall outlet? Confirm that
the plug is not abnormally hot.
Check the power cord for cracks and damage. Should the slightest irregularity
be observed, contact the authorized service centre.
26