Troubleshooting - Hisense SC-242 User's Operation Manual

Troubleshooting

In case of the following
Power failure
Keep opening and closing of the door to a minimum.
Avoid placing new items in the cooler as this will raise the temperature inside
the compartment.
When not used for a long period
Remove all items from the compartment and disconnect the power cord plug
from the wall outlet.
Clean the compartment interior and wipe away all water. To prevent mold
formation and bad smell, leave the door open to dry the compartment
completely.
Transportation
Disconnect the power cord plug from the wall outlet.
When moving the cooler, make sure that the feet do not damage the power
cord.
Do not let the feet hit against floor steps, thresholds, etc.
Temporary storage
Affix a piece of wood, etc. Between the door and main unit to prevent complete
closing of the door.
Make sure not to store the unused cooler at a location where children play.
Should a child enter the compartment and the door is closed, the child may not
be able to open the door from the inside.
27
Please check the following items if you encounter problems with the unit. If the
problem continues after taking the proper actions, disconnect the power cord
plug from the wall outlet.
Transfer the items stored in the cooler to a box or other container. Then contact
the authorized service centre.
PROBLEM CAUSE
No Is the power supply interrupted?
refrigeration
Is the power cord plug disconnected from the wall outlet?
at all
Are the power fuses blown and/or the circuit breaker activated?
Is the temperature setting appropriate?
Inadequate
Are items obstructing the cold air inlet and suction outlet?
refrigeration
Are stored items packed too tight?
Is the door open or is it opened and closed frequently?
Is the condenser clogged?
Excessive Are the unit leveled?
noise
Is the rear panel of the cooler contacting the wall or other
objects?
Are other objects in contact with the cooler?
Condensation may happens on the exterior and door during hot
Condensation
and humid days or depending on the place of installation. This
on Showcase
occurs when the humidity is high and water particles in the air
exterior
contact cold surfaces.
This is normal. Wipe away condensation with a dry cloth.
The Showcase sometimes stop running when thermostat turns off.
28