Procedure - tams elektronik KSM-3 Manual

tams elektronik KSM-3

2.3. Procedure

Phase 1: According to the current position of points the locomotive runs clockwise or counter-
clockwise through the terminal loop. When the train is intended to run in a specific direction
through the loop, the points can be set accordingly from the outside.
Phase 2: When the train running into the loop arrives at the sectioning point behind the
points, the polarity within the loop is altered (if necessary).
Phase 3: When the train running out of the loop arrives at the sectioning point before the
points, the polarity within the loop is altered and at the same time the points are set properly
for the train to run out of the terminal loop.
Operation overview | 7