Basic Operation - B9Creations Cure XL Instructions For Use Manual

• Duty Cycle
Duty cycle is the ratio between pulse duration and the period (the picture
below shows the difference between each cycle). Depending on the
shrinking rate of the material, operator can set the duty cycle from level1
(10%) to level 10 (100%).
Suggestion: When curing small and/or thin material, lower the duty cycle
level to reduce the shrinkage and deformation rate.
• Curing Time
Set the time between 5 seconds – 9:55 minutes with 5-second intervals, and
set the time between 10 minutes – 30 minutes with 1-minute intervals.

5.3 Basic Operation

1. Turn on the Power Switch.
2. Press
3. Press
4. Press START to cure.
9
to power on.
to set up IDT.