Table of Contents
Advertisement
Available languages
Available languages
Fault
After pressing the flash
test button, the transmitter
works but the receiver
does not
After pressing the flash
test button, the transmitter
works but the flash unit
does not
Cleaning and maintenance
Before cleaning, remove the transmitter from the camera and the
receiver from the flash unit. Disconnect the power supply for the
transmitter and receiver (remove the battery and pull out the mains
plug).
Clean the device only on the outside with a dry cloth. To avoid damage
to the electronics do not use cleaning fluids.
Protect all components from dust and moisture!
Store all parts in the supplied packaging in a dry and dust-free place.
Remove the batteries from the device if it will not be used for a long time!
Disposal
Dispose of the packaging materials properly, according to their
type, such as paper or cardboard. Contact your local waste-
disposal service or environmental authority for information about the
proper disposal.
Do not dispose of electronic devices in the household waste!
According to the European Directive 2012/19/EU on Waste Electrical
and Electronic Equipment and its transposition into national law, used
electrical equipment must be collected separately and recycled in an
environmentally sound manner.
Batteries and rechargeable batteries must not be disposed of with
10
Possible cause
a) The channel settings on
the transmitter and the
receiver are incorrect
a) Sync
connection
between the receiver
and the flash unit is not
correct
b) Flash unit is not on
Solution
Set the same channels on
the transmitter and the
receiver
a) Check
the
connection
between
receiver and flash unit
b) Turn on the flash unit
and press flash test
button to test flash
function
sync
Advertisement
Table of Contents
