Important Note - Bresser T-16 Instruction Manual

Receiver (Fig. 3)
9. Jack plug 3.5mm (Sync)
10. Jack plug adapter
11. C14 IEC connector
12. DIP switches (channel selection)
13. Function light (reception)
14. C13 power socket (AC 110V - 220V)
External parts* (Fig. 3)
15. C14 IEC connector
16. Euro power plug
17. Power outlet
Assembly and power supply
Assembly and power supply of the transmitter (Fig. 2)
The transmitter is powered by a battery.
1. The transmitter is already equipped with a suitable battery at the
factory. To change the battery, use a small Phillips screwdriver* (Fig. 2,
X) to unscrew the screw (Fig. 2, 3) on the underside of the transmitter
(Fig 1, A) and open the housing.
2. Insert a 12V battery, type 23A, in the holder (Fig. 2, 8).
3. Bring the two housing parts back together and screw them together.
4. Turn the locking wheel (Fig. 2, 5) on the transmitter all the way up.
5. Slide the transmitter (Fig. 1, A) with its lightning contact (Fig. 2, 4) into
the hot shoe of the camera*.
6. Turn the locking wheel (Fig. 2, 5) downwards and hand-tighten it.
Assembly and power supply of the receiver (Fig. 3)
The receiver is powered by mains power.

IMPORTANT NOTE!

A flash unit with a C13 power socket (for C14 IEC connector) is required
for the connection.
1. Put the jack plug (Fig. 3, 9) – if necessary with attached adapter (Fig. 3,
10) – into the connection socket (sync port) on the flash unit*.
2. Put the C14 IEC connector (Fig. 3, 11) into the C13 power socket on
the flash unit*.
3. Put the C14 IEC connector (Fig. 3, 15) of the power cord* from the
flash unit* into the C13 power socket (Fig. 3, 14) on the receiver.
4. Put Euro power plug (Fig. 3, 16) of the power cord* into the mains
socket (Fig. 3, 16, A).
*not included with the purchase
7