Troubleshooting - Bresser T-16 Instruction Manual

Commissioning of the remote trigger set
1. At the transmitter (Fig. 1, A) and on the receiver(s) (Fig. 1, B) set the
same channel.
2. Turn on the camera*. The function light (transmission / Fig. 2, 2)
lights up. Make the following camera settings: Recording mode 'M'
(manual), shutter speed 1/125 sec.
3. Switch on the flash unit with the receiver installed. The function light
(receipt / Fig. 3, 13) lights up.
4. Flash test button (Fig. 2, 1) to trigger a test flash. If a flash is triggered,
the connection is established and a flash can also be triggered using
the camera's* shutter release button.

Troubleshooting

Fault
After connecting the
receiver to the flash unit
and turning on the flash
unit, neither the receiver
nor the flash unit work
After connecting the
receiver to the flash unit,
the flash unit is ready
and works normally but
the remote trigger does
not work
The receiver is operational
but the flash unit is not
After pressing the flash
test button, neither
the transmitter nor the
receiver work
*not included with the purchase
Possible cause
a) Flash unit is not on
b) Receiver is not properly
connected
Remote trigger set is
defective
a) Flash unit is not on
b) The receiver and flash
unit are not connected
properly
a) Low/No battery power
b) Flash test button is
defective
Solution
a) Turn on the flash unit
b) Check connection of
the receiver to the flash
unit
Contact a dealer to
arrange repair or
replacement
a) Turn on the flash unit
b) Check connection of
the receiver to the flash
unit
a) Replace the battery
b) Contact a dealer to
arrange repair or
replacement
9