Huawei FusionModule2000 Maintenance Manual page 16

FusionModule2000 Smart Modular Data Center
Maintenance Guide
●
●
Figure 1-2 Requirements on the cabinet tilt angle
Using Ladders
●
●
●
●
Issue 02 (2022-07-30)
the equipment, secure it to the forklift truck using ropes. When moving the
equipment, assign dedicated personnel to take care of it.
Choose a road with good conditions or sea for transportation to ensure
equipment safety. Avoid tilt or jolt during transportation.
Move a cabinet with caution. Any bumping or falling may damage the
equipment.
Use wooden or fiberglass ladders when you need to perform live working at
heights.
When a step ladder is used, ensure that the pull ropes are secured and the
ladder is held firm.
Before using a ladder, check that it is intact and confirm its load bearing
capacity. Do not overload it.
Ensure that the ladder is securely positioned. The recommended angle for a
ladder against the floor is 75 degrees, as shown in the following figure. An
angle ruler can be used to measure the angle. Ensure that the wider end of
the ladder is at the bottom, or protective measures have been taken at the
bottom to prevent the ladder from sliding.
Copyright © Huawei Digital Power Technologies Co., Ltd.
1 Safety Information
9