Sharp AR-P350 Service Manual page 26

[7] DISASSEMBLY AND ASSEMBLY, MAINTENANCE
1. Self print of setup value
By using the self print mode (Pattern 98) of diag, the setup values and the jam history of the machine can be printed.
Before maintenance and disassembly procedures, they must be printed in advance.
2.Maintenance System Table
A. Engine section
Check (Clean, replace, or adjust as necessary.)
Unit name
Drum peripheral Drum
Cleaner blade
Toner reception seal
Side molt
Transfer roller
Discharge plate
TR bearing (F/R)
Transfer roller collar
After-transfer star ring
TR gear
Screen grid
Drum separation pawl UN
Charger case (M/C)
Charging plate
(saw teeth)
Developing section Developer
DV blade
DSD collar
DV side seal F
DV side seal R
Toner cartridge
Fusing section Upper heat roller
Lower heat roller
Upper separation pawl
Lower separation pawl
Thermistor
Upper heat roller gear
Paper guides
Gears
Cleaning roller
CL roller collar
Filters Ozone filter
Paper feed section Paper feed roller
Torque limiter
Transport section PS follower roller
Paper exit reverse section
Transport rollers
Transport paper guides
Paper dust remover
Drive section Specified position
Belts
Image quality
Other Sensors
Note 1:Replacement reference: Use the counter value of each paper feed port as the replacement reference.
Clean
When
Part name
calling
( )
( )
Paper feed roller/Torque limiter section: 80K or 2 years
AR-P350 DISASSEMBLY AND ASSEMBLY, MAINTENANCE 7-1
Replace Adjust
50K 100K 150K 200K 250K 300K 350K 400K
Maintenance cycle : 50K
Lubricate Move position
Remark
Installed when shipping
Supplied when installing
Attached when installing./
EX Japan: 814g,
user replacement for every 27K.
Clean and remove paper dust.
Note 1
Note 1