Aldor Automotive KIA6RISU Mounting Instructions

Mounting

1. Thoroughly clean the mounting surface of the trunk lid with the enclosed degreaser tissue. (fig. 1).
2. Use sandpaper to roughen up the mounting surface. Make sure not to damage the protective film on the
double sided tape. (fig. 2).
3. Carefully peel off the ends of the double sided tape and make sure that the ends protrude outside the
surface of the spoiler. (fig. 3). Do NOT remove the protective film entirely !
4. Apply the enclosed spoiler glue to the mounting surface of the spoiler. (fig. 3).
5. Place the spoiler on the trunklid of the car in such way that the 2 little hooks on the spoiler touch the
edges of the trunklid. (fig. 4) Make sure that the ends of the protective film on the double sided tape
protrude between the spoiler and the trunklid.
6. Pull out the protective film from between the spoiler and the trunklid. (fig. 5).

ATTENTION:


Allow the glue to dry and do not drive the car for 12 hrs. During 24 hrs no mechanical loading
should be applied to the part. Do not wash for 48 hrs.

No warranty acceptance of any damage due to the use of a car wash.
MOUNTING INSTRUCTIONS
Kia Rio (YB) 2017- 5d roofspoiler
Art.nr. : KIA6RISU
Material : ABS

Parts list

:
Part
Spoiler
Degreaser tissue
Tube spoilerglue 80 ml.

Required tools:

- sandpaper
KIA6RISU NL-ENG / 18-01-23 / page 1
Van Hilststraat 4
5145 RL Waalwijk
The Netherlands
tel: +31-416-344 778
fax: +31-416-344 984
www.aldorautomotive.com
Qty
1
1
1