ROVI X3 User Manual page 36

III
Controller Diagnostics
In the unlikely event that the ROVI
will display one of several error codes to help diagnose the problem. Please see Table 1 for more
information.
Note: If performing the applicable procedure from Table 1 does not clear the corresponding fault,
DO NOT continue use of the power wheelchair. Turn off the power to the joystick controller and
consult your service provider immediately.
Table 1
BATTERY
GAUGE
An excessive voltage has been applied to the control system. This is usually caused by
10 bars flash
a poor battery connection.
The parking brakes have a bad connection. Check the parking brake and motor
9 bars flash
connections.
8 bars flash A control system fault is indicated. Make sure that all connections are secure.
A joystick fault is indicated. Make sure that the joystick is in the center position be-
7 bars flash
fore switching on the control system.
6 bars flash Battery charger connected.
5 bars flash Right-hand motor wiring fault.
4 bars flash Right-hand motor disconnected.
3 bars flash Left-hand motor wiring fault.
2 bars flash Left-hand motor disconnected.
1 bar flashes Low battery voltage.
® X3 power wheelchair begins to malfunction, the VR2/R-Net
POSSIBLE FAULT
36