ROVI X3 User Manual page 17

equipped with a VR2 control system can support up to two actuator motors.
One Actuator is Installed on the Power Wheelchair:
With the VR2 powered on, press either actuator button to activate actuator adjustment mode. The
LED above each actuator button will light up.
Push the joystick forward or backward to adjust the actuator to the desired position.
Release the joystick to stop actuator adjustment.
Press either actuator button to return to drive mode. The LED above each actuator button will go
out.
Two Actuators are Installed on the Power Wheelchair:
With the VR2 powered on, press either the left or the right actuator button, depending on which
actuator you wish to adjust. The LED above the selected actuator will light up.
Push the joystick forward or backward to adjust the actuator to the desired position.
Release the joystick to stop actuator adjustment.
Press the selected actuator button to return to drive mode. The LED above the actuator button will
go out.
Note: If you wish to adjust the second actuator before returning to drive mode, press the other ac-
tuator button and repeat the steps 1 – 4 above.
Charging Port/Lighting Descriptions
See the Charging Port and Lighting Options sections under R-Net Joystick Controller.
II
17