ROVI X3 User Manual page 23

Sleep Mode
If the control system is left on and not used for more than 10 minutes, it may automatically "go to
sleep." This is recognized by a slow intermittent flash of the battery gauge on the VR2 and R-Net
and by a "ZZZ" symbol on the R-Net with LCD screen. Simply turn the control system off and back
on to reset.
Drive/Freewheel Mode
The drive/freewheel levers are found at the rear of the drive wheel on either side of the power
wheelchair (Figure 15). These levers will allow you to disengage the electromagnetic brakes so that
you can push the power wheelchair manually.
Make sure the VR2/R-Net is powered off. To place your power
wheelchair into freewheel mode, push both drive/freewheel
levers down. This will disengage the electromagnetic brakes. To
return the power wheelchair to drive mode, pull both levers up.
Press the on/off button to power on the VR2/R-Net. If the battery
gauge is not flashing, proceed to drive your chair as normal. If the
battery gauge is flashing, then double check that the drive/free-
wheel levers have been engaged fully in the up position.
Main Circuit Breaker
The main circuit breaker is a safety device that will trip to protect the motor and electronics when
they are subjected to excessive loads. It is located at the rear (right side) of the unit and can be
reset, should a trip occur.
If a circuit breaker trip occurs, allow the power wheelchair to rest for approximately 1 minute
before depressing the circuit breaker button. Should frequent circuit breaker trips occur, please
contact your ROVI X3 provider.
®
II
23
Drive
Freewheel
Figure 15