When Viewing A Dvi Digital Signal; Connecting The Supplied Power Cable - NEC HT1000 User Manual

When Viewing a DVI Digital Signal:

To project a DVI digital signal, be sure to connect the PC and the projec-
tor using a DVI-D signal cable (not supplied) before turning on your PC
or projector. Turn on the projector first and select DVI (DIGITAL) from
the source menu before turning on your PC.
Failure to do so may not activate the digital output of the graphics card
resulting in no picture being displayed. Should this happen, restart your PC.
Do not disconnect the DVI-D signal cable while the projector is running. If
the signal cable has been disconnected and then re-connected, an im-
age may not be correctly displayed. Should this happen, restart your PC.

Connecting the Supplied Power Cable

Connect the supplied power cable to the projector.
First connect the supplied power cable's three-pin plug to the AC IN of
the projector, and then connect the other plug of the supplied power
cable in the wall outlet.
AUDIO IN
VIDEO VIDEO
PC CONTROL VIDEO IN S-VIDEO IN
Audio cable (not supplied)
PHONE
E-17
DVI-D IN
S-VIDEO S-VIDEO COMPONENT RGB/DVI RGB/DVI AUDIO IN AUDIO IN SC TRIGGER
DVI-D IN
Y Cb/Pb Cr/Pr
RGB IN
NOTE:
• Use the DVI-D cable compliant with DDWG (Digital Display Working Group)
DVI (Digital Visual Interface) revision 1.0 standard. The DVI-D cable should
be within 5 m (196") long.
• The DVI (DIGITAL) connector accepts VGA (640x480), SVGA (800x600), XGA
(1024x768) and HDTV 1080p, 1080i, 720p, 750p, 480p, 480i, 525p, 576p
and 625p.
VID EO VID EO
S-V IDE S-V IDE
PC CO O O
CO MP ON
NT RO L ENT
RG B/D RG B/D
VID EO VI VI
IN AU DIO AU DIO
S- VID EO IN IN
SG TR
IN
IG GE R
Y
Cb /Pb
Cr /Pr
RG B IN
DVI-D Signal cable (not supplied)
DV I-D
IN