When Viewing A Dvi Digital Signal (Except Np405 And Np305) - NEC NP 610 User Manual

When Viewing a DVI Digital Signal (except NP405 and NP305)

To project a DVI digital signal, be sure to connect the PC and the projector using a DVI cable (not supplied) before
turning on your PC or projector. Turn on the projector first and select Computer 2 (Digital) from the source menu before
turning on your PC.
Failure to do so may not activate the digital output of the graphics card resulting in no picture being displayed. Should
this happen, restart your PC.
Do not disconnect the DVI cable while the projector is running. If the signal cable has been disconnected and then
re-connected, an image may not be correctly displayed. Should this happen, restart your PC.
NOTE:
• Use a DVI cable or the one compliant with the DDWG (Digital Display Working Group) DVI (Digital Visual Interface) revision 1.0
standard. The DVI cable should be within 5 m (196") long. Both single and dual types of DVI cable can be used.
• The DVI (DIGITAL) connector accepts VGA (640 x 480), SVGA (800 x 600), 1152 x 864, XGA (1024 x 768), WXGA (1280 x 800
@ up to 60Hz), and SXGA (1280 x 1024 @ up to 60Hz).
Audio cable (not supplied)
AUDIO IN
DVI cable (not supplied)
COMPUTER 2 (DVI-I) IN
19
2. Installation and Connections
IBM PC or Compatibles (Desktop type)
or Macintosh (Desktop type)
PHONE