Advertisement
MAKING THE ESE (EASY SERVE ESPRESSO) POD ESPRESSO
1.
Insert the ESE Pod Filter into the Filter holder, fill in one ESE pod into the filter.
Note :
the ESE Pod Filter.
2. Insert the Filter holder into the Brew unit with a 45° movement to the left and turn it
to the right to lock it in place. The Filter holder handle must be perpendicular to the
machine or slightly tilted towards the right.
3.
Wait until the Temperature ready indicator light turns blue.
4.
Press the Espresso button. The machine will start brewing.
5.
Stop the brewing process when the cup is 3/4 full (about 30-40ml/1.0-1.4fl.oz) by
pressing the Espresso button again. The coffee will be more or less intense
depending on the amount of water used and, if prepared following the correct
procedure, it will have the typical hazelnut /brown colored " natural crema ".
If no any coffee come out when brewing or Filter holder is too tight to be removed
6.
after brewing, coffee filter is considered blocked. Before slowly removing the
Filter holder it is important to turn on the Steam control knob and wait until the
machine cold down to room temperature.
To brew another ESE Pod espresso, slowly and carefully remove the Filter
7.
holder to the " unlock " position. Remove the ESE pod from the ESE Pod Filter.
Note :
ESE pod. Once the Filter holder has been removed, some water will
still drip. This is due to the water pressure in the system.
HOW TO USE
Each time fill in one ESE pod, don't fill two or more pods in
Be careful not to burn yourself with the water left on the
9
Hide quick links:
Advertisement
