Electrolux ENC2854AOW User Manual page 15

Problem
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
The compressor does not
start immediately after
pressing the Shopping, or
after changing the temper‐
ature.
Water flows inside the re‐
frigerator.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The door is not closed
correctly.
The FastFreeze is
switched on.
The Shopping is switch‐
ed on.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The FastFreeze or Shop‐
ping mode is switched
on.
The appliance is in dem‐
onstration mode.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
ENGLISH
Solution
Refer to "Closing the door".
Refer to "FastFreeze mode".
Refer to "Shopping mode".
The compressor starts after
a period of time.
The compressor starts after
a period of time.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto‐
matically to set the tempera‐
ture. Refer to "FastFreeze or
Shopping mode".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
15