I
NSTALLATION
Step 1: Please connect wires from the DC power source to the
terminal block on the front panel of the DMC-1001.
Step 2: Turn on the DC power source.
Step 3: Turn on the chassis system by flipping the switch beside
the receptacle to ON position. The LED on the front panel
of the chassis system will come on then.
Installing and Removing the Power Supply
To install a power supply to the chassis, you have to
slide in the power supply to the chassis and fasten the
hand screw clockwise.
To remove a power supply out the chassis, you have to
loose the hand screw counter clockwise and pull out
the power supply from the chassis.
Y o u c a n s l id e i n a n d o u t t h e p o w e r s u p p l y f r o m t h e b a y ,
f a s t e n o r lo o s e t h e h a n d s c r e w c l o c k w is e o r c o u n t e r
c l o c k w i s e b y u s i n g h a n d o r s c r e w d r i v e r.
S
PECIFICATIONS
DMC-1001
3