2-17. Card Wlan/Bt Combo - Sony SRS-X88 Service Manual

SRS-X88

2-17. CARD WLAN/BT COMBO

Note 1: Be sure to replace the complete NETWORK board and card WLAN/
BT combo at the same time. Be sure to also follow "NOTE OF RE-
PLACING THE COMPLETE NETWORK BOARD AND CARD
WLAN/BT COMBO" on page 3 during replacement.
Note 2: When replacing the card WLAN/BT combo, refer to "CHECKING
OF NETWORK CONNECTION" on page 3.
3 Remove the card WLAN/BT combo
block in the direction of the arrow.
8 two sheets (1)
7 holder (WI-FI)
2 screw
(BTTP M2.6
9 card WLAN/BT combo
Note 3: When affixing the tape, be careful
that it does not obstruct the hole.
card WLAN/BT
combo
tape
20 mm
(sub material)
sheet (1)
guide line
card WLAN/BT
combo
22
1 tape
(sub material)
A
8)
A 5 antenna
connector
(CON4)
6 screw
(BVTT2.6 4)
guide line
heat sink (lower)
sleeve ferrite
clamp (FC1)
guide line
sheet (1)
card WLAN/BT
combo
4 card WLAN/BT combo
connector
1 tape
(sub material)
tape
(sub material)
Insert the connector straight into the interior.
There is a possibility that using this unit without
the connector correctly installed will damage it.
OK
Insert straight into Insert only part way.
the interior.
connector
connector
connector connector
card WLAN/BT combo
Note 4: The antenna wire must not
touch the shield portion.
antenna wire
NG NG
Insert at a slant.
connector
connector