Resetting The Unit; Canceling The Demo Mode; Preparing The Card Remote Commander; Setting The Clock - Sony MEXBT3800 Operating Instructions Manual

E:\SONY\ME\851287S_MEX-
BT3800U_U\0702\4158429111\4158429111MEXBT3800U\01US02CD-U.fm
00US+00COV-U.book Page 10 Friday, July 3, 2009 11:12 AM

Resetting the unit

Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel (page 10) and press the
RESET button (page 18) with a pointed object,
such as a ball-point pen.
Note
Pressing the RESET button will erase the clock setting
and some stored contents.

Canceling the DEMO mode

You can cancel the demonstration display which
appears during turning off.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until "DEMO" appears.
3
Rotate the control dial to select
"DEMO-OFF."
4
Press and hold the select button.
The setup is complete and the display returns
to normal reception/play mode.
Preparing the card remote
commander
Remove the insulation film.
Tip
For how to replace the battery, see page 40.

Setting the clock

The clock uses a 12-hour digital indication.
The clock uses a 24-hour digital indication.
The clock uses a 12-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until "CLOCK-ADJ" appears.
3
Press (SEEK) +.
The hour indication flashes.
10
4
Rotate the control dial to set the hour
and minute.
To move the digital indication, press (SEEK)
–/+.
5
After setting the minute, press the
select button.
The setup is complete and the clock starts.
To display the clock, press (DSPL). Press
(DSPL) again to return to the previous display.
Tip
You can set the clock automatically with the RDS
feature (page 24).
Tip
You can set the clock automatically with the RDS
feature (page 25).
Tip
You can set the clock automatically with the RDS
feature (page 26).

Detaching the front panel

You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press and hold (SOURCE/OFF).
The unit is turned off.
2
Press
(SOURCE/OFF)
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
• Do not detach the front panel during playback of the
USB device, otherwise USB data may be damaged.
MEX-BT3850UMEX-BT3800UMEX-BT3800U
4-158-429-51(1)4-158-429-31(1)4-158-429-11(1)
masterpage:Left
, then pull it off towards you.