Cleaning, Maintenance And Ordering Spare Parts; Storage; Disposal And Recycling - Scheppach DECO-FLEX Instruction Manual

13. Cleaning, maintenance and
ordering spare parts
WARNING
Always switch the machine off and remove the mains
plug prior to all maintenance and cleaning work.
13.1 Cleaning
Keep protective devices, air vents and the motor hous-
ing as free of dust and dirt as possible. We recommend
cleaning the device directly after every use.
13.1.1 Exterior cleaning
• Clean the device at regular intervals using a damp
cloth and a little soft soap.
• Do not use cleaning agents or solvents. These could
damage the plastic parts of the device.
• Make sure that no water can penetrate the device
interior.
13.2 Maintenance
13.2.1 Bearings (Fig. 15)
Lubricate the bearings of the deflection rollers af-
ter approx. 25-30 operating hours at the latest using
high-quality machine grease.
13.2.2 Carbon brushes
If excessive sparks are generated, have an electrician
check the carbon brushes.
ATTENTION
The carbon brushes must only be replaced by an elec-
trician.
13.2.3 Mains cable
If the mains cable is pulled out, cut, or damaged in
some other form, then it should be replaced immedi-
ately.
13.3 Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Carbon brushes, saw blade, table inlay
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
30 | GB
13.4 Ordering spare parts
Please note that the following information must be pro-
vided when ordering spare parts:
• Device type
• Device article number

14. Storage

Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the power tool in its original packaging.

15. Disposal and recycling

waste disposal sites. Check with your specialist dealer
or municipal administration!
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product
must be handed over at the intended collection point.
This can be done, for example, by returning it when
purchasing a similar product or delivering it to an au-
thorised collection point for the recycling of old electri-
cal and electronic devices. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially haz-
ardous substances that are often contained in electri-
cal and electronic equipment. By properly disposing of
this product, you are also contributing to the effective
use of natural resources. You can obtain information on
collection points for waste equipment from your munic-
ipal administration, public waste disposal authority, an
authorised body for the disposal of waste electrical and
electronic equipment or your waste disposal company.
www.scheppach.com
The device is supplied in packaging to avoid
transport damages. This packaging is raw
material and can thus be used again or can
be reintegrated into the raw material cycle.
The device and its accessories are made of
different materials, such as metals and plas-
tics. Take defective components to special