Automatic Search - Ten-Haaft Oyster Vision II Operating Instructions Manual

Automatic search

After switching on the system with the key , the antenna extends and
aligns itself first to the position on which a satellite had been received
the last time. If no satellite can be received there, the system begins
automatically with the fully automatic search for the preset satellite
(factory pre-set to ASTRA 1). In the chapter Menu option "Settings" on
page 12 you learn how to change this search satellite.
After the search satellite has been found the search stops and the TV
picture is switched through. If after prolonged search (several minutes)
still no TV picture appears, then you are probably in an area where the
preset satellite cannot be received or there is an obstacle in the receiving
direction of the system. In this case the message "not found?" appears
on the display of the controller. In that case you should select another
search satellite or make sure that no obstacle obstructs reception; or
change the present location, if necessary.
The fully automatic search always assumes that your vehicle is standing
perfectly horizontally. If this should not be the case then you will
possibly experience prolonged search times.
When the system has already been extended, the fully automatic search
can again be started as follows:
- Press the key
repeatedly until the message "Automatic search"
appears on the display.
- Press the key .
If at the end of the automatic search the receiver is not switched on, then
a corresponding message is shown on the display.
8