Switching On And Off - Ten-Haaft Oyster Vision II Operating Instructions Manual

Switching on and off

The operation of your Oyster Vision is very simple. You only have to
press the key , and your Oyster Vision will immediately start up.
Please do not forget, however, to switch on your satellite receiver and
your TV set or flat-panel display. The Oyster Vision works completely
independent from TV set and receiver; however, if these devices are
switched off naturally no TV or radio reception is possible.
After switching on, the antenna dish extends and first moves into the
position of the last satellite identification. If since then the vehicle
location has been changed, the system does not recognize any signals
and it begins the fully automatic satellite search.
For the selection (the basic setting) of the desired satellite, please refer to
the chapter Menu option "Settings" (see page 12).
If no picture appears after extending the antenna and the system does
not change into the automatic search mode, then it had been operated in
the manual mode before last switching it off. Please refer for this case to
the chapters "Automatic search" and "Manual search" (see pages Fehler!
Textmarke nicht definiert. & Fehler! Textmarke nicht definiert.).
In order to switch off the system, simply press the key again so that
the Oyster Vision immediately retracts and then changes into the standby
mode.
If you want to stop the motion of the system during a search in
progress, simply press the key and the antenna will immediately
remain stationary.
6