The First Steps - Ten-Haaft Oyster Vision II Operating Instructions Manual

The first steps

We have included separate instructions for the assembly and first start-up
as well as the necessary wiring work of your Oyster Vision in the
Assembly Instructions. All steps from unpacking through the assembly
and the connection up to the first switching-on together with various
basic adjustments are described there. If you carefully proceeded with all
steps described in the Assembly Instructions, now a fully functional
Oyster Vision should be at your disposal.
The entire operation is performed by using the operating control.
Vision
You can attach this operating control device at any place of your choice,
but please consider, however, that it is not waterproof. Possibly you may
yet have to pull off the protective plastic film from the display.
On the display area of the operating control you are also presented with
various pieces of information about the current operating condition of
your system. In order to be able to read this information it is advisable to
place the operating control at an easily accessible place. Since the display
is back lit, it can also be read without problems when it is installed at a
very dark place.
4