Troubleshooting - Whirlpool AKP 447/IX/01 Quick Manual

4.
Refit the upper edge: a click will indicate correct
positioning. Make sure the seal is secure before
refitting the door.
MOVING THE TOP HEATING ELEMENT (SOME
MODELS ONLY)
1. Remove the side accessory holder grilles.
2. Pull the heating element out a little and lower it.
3. To reposition the heating element, lift it up,
pulling it slightly towards you, be sure it comes to
rest on the lateral supports.

TROUBLESHOOTING

Problem
The oven does not work.
REPLACING THE LAMP
Disconnect the oven from the power supply, unscrew
the cover from the light, replace the bulb and screw
the cover back on the light.
Reconnect the oven to the power supply. Do not use
the oven until the light cover has been refitted.
Please note: Only use 25W/230 ~ V, G9 type, T300°C
halogen bulbs. The bulb used in the product is
specifically designed for domestic appliances and
is not suitable for general room lighting within the
home. Light bulbs are available from our After-sales
Service.
Possible cause
Power cut.
Disconnection from the
mains.
Solution
Check for the presence of mains electrical power
and whether the oven is connected to the
electricity supply.
Turn off the oven and restart it to see if the fault
persists.
EN