Table of Contents
Advertisement
3 / fit the large
screw without
forgetting
the
spacer
Put
the
2
remaining screws
and tighten the
assembly
Fit
the
lower
protection grid
using the 4 screws
and nuts
3.
Place the handle on the hopper and line up all of the holes. Secure it with flat washer
(Ø8, 4pcs), spring washer (Ø8, 4pcs) and bolt (M8x20, 4pcs). (See Pic.3)
4.
Place the funnel over the studs in the side of the chipper/shredder and secure it with
Pic.3 Installing the handle
11
Advertisement
Table of Contents
