Specifications - NEC MultiSync LCD1525V User Manual

Specifications

Monitor
Specifications
LCD Module
Viewable Image Size:
Native Resolution (Pixel Count):
Input Signal
Analog input:
Display Colors
Viewing Angle
Up/Down:
Horizontal:
Synchronization
Range
Resolutions Supported
Resolution based on horizontal and
vertical frequencies only
Horizontal:
Active Display Area
Power Supply
Current Rating
Dimensions
Weight
Environmental Considerations
Operating Temperature:
Storage Temperature:
*
Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may
appear different. This is normal and necessary for all current flat panel technologies when displaying non-native
resolutions full screen. In flat panel technologies, each dot on the screen is actually one pixel, so to expand resolutions to
full screen, an interpolation of the resolution must be done.
NOTE: Technical specifications are subject to change without notice.
78134641.wpc
MultiSync ®
Monitor
Diagonal: 15.1 inch
15.1 inch
1024 x 768
Video: ANALOG 0.7 Vp-p/75 Ohms
Sync: Separate sync. TTL Level
Horizontal sync. Positive/Negative
Vertical sync. Positive/Negative
16,194,277 colors with dithering
Left/Right: 55
40
24.8 kHz to 48.4 kHz
Vertical: 56.2 Hz to 75.0 Hz
720 x 400* VGA text
640 x 480* at 60 Hz to 75 Hz
800 x 600* at 56 Hz to 75 Hz
1024 x 768 at 60 Hz ................................ NEC cites recommended resolution at
307 mm/12.1 inches
Vertical: 230 mm/9.1 inches
AC 100 – 240 V @ 50/60 Hz
0.4 A @ 100 – 120 V/0.25 A @ 220 – 240 V
370 mm (W) x 325 mm (H) x 151 mm (D)
14.6 inches (W) x 12.8 inches (H) x 5.9 inches (D)
4 kg
8.8 lbs
5 C to 35 C/41 F to 95 F
Humidity: 30% to 80%
Feet: 0 to 10,000 Feet
-10 C to +60 C/14 F to 140 F
Humidity: 10% to 85%
Feet: 0 to 45,000 Feet
10
12
LCD ™ Notes
1525V
Active matrix; thin film transistor (TFT)
liquid crystal display (LCD); 0.30 mm dot
pitch; 200cd/m 2 white luminence;
200:1 contrast ratio, typical
Depends on display card used.
Automatically
Automatically
Some systems may not support
all modes listed.
60 Hz for optimal display performance.
Dependent upon signal timing used,
and does not include border area.
5/4/99, 5:38 PM