Table of Contents
Advertisement
A. HOT AIR GUN REWORKING
1.
Plug the power cord.
2.
Turn on the upper right hand switch. Digital readout of current temperature
will appear.
3.
Adjust temperature and airflow according to the type of component being
reworked. NOTE: If reworking plastic or larger components, higher tempera-
ture and airflow is needed.
4.
When proper adjustment of airflow and temperature has been set, wait a
few seconds for the temperature and airflow to stabilize.
5.
DESOLDERING. Maintain a 15mm distance between the component to be
reworked and the hot air gun. Move the air gun in a rotating manner focus-
ing around the component. When solder starts to melt and sparkle, check if
component can be moved. Use a tweezers or IC popper to detach the com-
ponent.
6.
SOLDERING.
soldered and the hot air gun. Move the air gun in a rotating manner focus-
ing around the component. Wait until the component bonds.
7.
Place handset to holder when not in use.
8.
Lower set temperature settings and in-
crease airflow after usage, wait for tem-
perature display to go below 150C.
9.
Turn off the hot air gun power switch.
B. SOLDERING IRON REWORKING
1.
Plug the power cord.
2.
Turn on the soldering iron switch. Power indicator will light up permanently.
3.
For first time usage, set temperature to 250
Melt some solder flux to cover the tip of the soldering iron rod. Keep solder-
ing iron tip covered with a thin layer of flux.
4.
When soldering iron is in standby, decrease temperature to 250
Turn off the switch if it exceeds 20 minutes of not using. This will guarantee
welding quality and lengthen heating element and tip usage life.
5.
Unplug power coed if not in use.
OPERATING GUIDE
Maintain a 15mm distance between the component to be
CAUTION! Do not let the air
stand in one position for more
than one second.
0
C until power indicator blinks.
0
C or below.
7
Advertisement
Table of Contents
Need help?
Do you have a question about the INT 899A+ and is the answer not in the manual?