Biostar M7VKD Manual page 60

Chapter2 BIOS Setup
LPT & COM
When set to On, any event occurring at a COM(serial)/LPT (printer)
port will awaken a system which has been powered down.
The Choices: NONE, LPT, COM, LPT/COM (default).
HDD & FDD
When set to On (default), any event occurring at a hard or floppy
drive will awaken a system which has been powered down.
The Choices: ON (default), OFF
PCI Master
When set to On, any event occurring at PCI will awaken a system
which has been powered down.
The Choices: OFF (default), ON.
PowerOn by PCI Card
When you select Enabled, a PME signal from PCI card returns the
system to Full ON state.
The Choices: Disabled (default), Enabled.
Wake Up On LAN/Ring
To use this function, you need a LAN add-on card which support
power on function. It should also support the wake-up on LAN jump.
Disabled (default) Wake up on LAN/Ring not supported.
RTC Alarm Resume
When "Enabled", you can set the date and time at which the RTC
(real-time clock) alarm awakens the system from Suspend mode.
The Choices: Disabled (default), Enabled.
Primary INTR
When set to ON (default), any event occurring at Primary INTR will
awaken a system which has been powered down.
The following is a list of IRQ, Interrupt ReQuests, which can be
exempted much as the COM ports and LPT ports above can. When an
I/O device wants to gain the attention of the operating system, it
signals this by causing an IRQ to occur. When the operating system is
ready to respond to the request, it interrupts itself and performs the
service.
As above, the choices are On and OFF. Off is the default.
When set On, activity will neither prevent the system from going into
2-25