Biostar M7VKD Manual page 46

Chapter2
Swap Floppy Drive
If the system has two floppy drives, you can swap the logical drive name
assignments.
The Choices: Enabled, Disabled (default).
Boot Up Floppy Seek
Seeks disk drives during boot up. Disabling speeds boot-up.
The Choices: Enabled (default), Disabled.
Boot Up NumLock Status
Select power on state for NumLock.
On (default)
Off
Gate A20 Option
Select if chipset or keyboard controller should control Gate A20.
Normal
Fast (default)
Security Option
This category allows you to limit access to the system and Setup, or just to Setup.
System
Setup (default)
OS Select For DRAM > 64MB
Select the operating system that is running with greater than 64MB of RAM on
the system.
The Choices: Non-OS2 (default), OS2.
Numpad is number keys.
Numpad is arrow keys.
A pin in the keyboard controller
controls GateA20.
Lets chipset control GateA20.
The system will not boot and access to
Setup will be denied if the correct
password is not entered in prompt.
The system will boot, but access to Setup
will be denied if the correct password is
not entered at the prompt.
2-11
BIOS Setup