Table of Contents
Advertisement
scan and then release the button. The tuner will stop scanning when it receives the next broadcasting
station of adequate signal strength.
5. Press the volume control VOLUME+/- Button on main unit or remote control to adjust the volume to the
desired level.
FM & FM-Stereo reception
– When listening to the FM radio, press the FM ST. Button on remote control or main unit to switch between
stereo mode and mono mode. The FM stereo icon "ST" will appear on the display if unit is in stereo mode. It
is preferable to receive the program in mono when you are receiving a weak station.
HINTS FOR BEST RECEPTION:
FM – For best FM reception, the FM lead wire antenna located on the back of the unit should be fully
unwrapped and extended
Automatic tuning depends on the signal strength of the broadcasting station, so weak stations
may be skipped. You can manually tune to nd the weak stations if a station gets skipped. With
strong signals, the tuner may stop before it reaches the actual broadcast frequency, so you may
need to manually tune for the best reception.
PRESET RADIO STATIONS
1. Press the POWER/ STANDBY C) BUTTON on top of the main unit or on the remote control to turn on the
unit.
2. If it is not in FM radio mode, tap the MODE Button to select FM radio mode.
3. Tune to the desired radio station either by "manually" or "automatically" tuning
4. Press and hold the PRESET/MEMORY Button on main unit or tap MEMORY Button on remote control,
display will show memory preset number "P01" ashing and memory icon "PROG" showing in the LED
display.
5. Tap the P+ or P- Button on remote control to select the preset number you want to assign the station to.
. Tap the MEMORY Button on remote control to con rm the
7. Repeat above steps 4 – 6 to preset up to 30 FM stations.
RECALLING PRESET MEMORY CHANNELS
In radio mode, to recall the pre-set channels by
1, Pressing the PRESET/MEMORY BUTTON on main unit, then tap the 1•or •1 Button repeatedly to select the
preset radio station you want.
2, Pressing P+ or P- Button on remote control repeatedly to select directly
PLAYING A CD
1. In Off (standby) mode, press the POWER/ STANDBY (9 BUTTON on top of the main unit or on the remote
control to turn the unit ON.
2. Tap the MODE Button to select CD mode.
3. Press the open/close button on remote control or button on top of the main unit to open the disc tray.
4. Place the CD with the label side up into the CD compartment, and then press the open/close button to
close the disc
5. Unit starts to read the disc, "READING" shows in display. After few seconds, the total number of tracks
show one second.
. PLAY indicator shows in display, the CD will start playing from rst
7. Press the volume control VOLUME+/- Button on main unit or remote control to adjust to the desired
volume level.
. To pause playback, press the PLAY/PAUSE ►11 Button on main unit or remote control. The elapsed timer
will be paused and the pause icon will be shown on the display. To resume playing, press the CD
Advertisement
Table of Contents
