How To Assemble; How To Disassemble; How To Clean - Richell 803840 94337-3 Instruction Manual

How to assemble

1.
Attach Panels
① Locate the hole on the bottom of the
Panel and insert the Wood Dowel on the
Coupling Rod in the direction as shown.
2.
Insert Holepins
Insert 2 Holepins in to the holes on
top of the Coupling Rods as shown.
Hole

How to disassemble

① Remove Caps.
② Remove Holepins as shown.
③ Slide Panel forward to separate from Coupling Rod
as shown.
(Do not force by pulling or twisting Coupling Rod.)
Cautions!
l Take care that product does not collapse while
disassembling.
l Leave Door locked when assembling Door Panel.

How to clean

l Use a mild detergent and water and clean with a soft cloth/sponge. Cleaning with a scrub brush and/or using a polishing
powder may cause scratched, rust and/or discolor this product.
l When using creosol or other disinfectants, make sure to dilute them, otherwise damage to the wooden finish or discoloration may occur.
l Do not use harsh chemicals such as thinner, benzene or alcohol as these may cause damage/discoloration to the finish.
l After cleaning, wipe dry with soft cloth or place in a shaded area to air dry; do not place product in direct sunlight.
lPlease note that product specifications and design may change without prior notice for the purpose of quality improvement.
lThere may be coating cracks at some joints and each product may experience different coloration of the wood grain as frames are made of natural wood.
lIf you find something wrong with this product, please let us know. Thank you!
Replacement parts may be purchased by contacting Richell USA directly at the
number listed at the below or at www.richellusa.com.
② Attach the top of the Coupling Rod to the Panel as shown.
(After inserting Wood Dowel, do not force the Coupling
Rod by twisting/turning.)
Wood Dowel
Hole
3.
Insert Caps
After selecting your desired configuration, insert Caps as shown.
Check to make sure each Cap is in position.
Cautions!
l Caps can only be inserted
at 90 or 180 degree angles.
l There will be a small gap
between Panel and Cap.
2
90 degree angle 180 degree angle
For USA Customers
Designed by:
Richell Corporation, Japan
Distributed by:
Richell USA, Inc.
Grand Prairie, Texas 75050
Phone (972) 641-9795 Fax (972) 641-8495
www.richellusa.com
Visit us at
MADE IN VIETNAM