Nice ERA INTI1, INTI2 - Remote Control Quick Start Guide

INTRODUCTION

Follow all safety and installation instructions properly to avoid serious injury. The installation must be carried out by a specialist. Find a dealer.
Keep this manual in a safe place for future reference.

WARNING

Read these instructions carefully before using the product. If in doubt, contact your dealer.

SPECIFICATIONS

• Transmission frequency: 433.92 MHz
• Number of buttons: INTI1 = 1 button, INTI2 = 2 buttons
• Coding: Rolling Code / Opera
• Power supply: 01 3V battery (CR 2032).

RECORDING CONTROLS AT THE CENTRALS

To encode this controller, the entire encoding process in the control panel manual must be followed. Please consult its manual.

BATTERY REPLACEMENT

1. Using a pointed-end object, press the open button behind the control;
2. Open carefully and remove the battery;
3. Insert the new battery and close the control.

ATTENTION:

• Check the correct polarity of the battery.
• After use, the battery should be disposed of in a suitable place.

CHANGING THE TRANSMITTER CODE

Check the manual for your center in Nice for the accepted transmission methods.

CHANGING TO "ROLLING CODE"

1. Remove the battery;
2. Press and hold key 1 on the transmitter;
3. Insert the battery;
4. Hold the key down for 10 seconds (the LED will beon during this period);
5. The transmitter LED will flash 3 times.

CHANGING TO "OPERA"

1. Remove the battery;
2. Press and hold key 2 on the transmitter;
3. Insert the battery;
4. Hold the key down for 10 seconds (the LED will be on during this period);
5. The transmitter LED will flash 4 times.

"This device has no right to protection against harmful interference and must not cause interference in properly authorized systems."

CLIENT SUPPORT

Follow on Facebook
/nicegroupbrasil

Watch on Youtube
/nicebrasil

Follow on Instagram
@nicebrasiloficial

From Monday to Thursday from 08:00 to 18:00

Friday 08:00 to 17:00

Telephone: +55 (19) 2113-2717

E-mail: atendimento@nice.com.br