Low Battery Warning; Pairing The Gate Sensor - Swann Gate Alert Kit Instruction Manual

Low battery warning

Your devices will let you know when batteries are running low
on power.
• Install new batteries immediately for the Indoor Alarm
Receiver when all four LED indicators start blinking at the
same time.
• Install new batteries immediately for the Gate Sensor
when the status LED starts blinking continuously.

Pairing the Gate Sensor

The Gate Sensor and Indoor Alarm Receiver in your kit have
already been paired so all you have to do is put batteries in and
your devices are ready to use. If for some reason pairing is lost,
here's how to pair them again:
1. Make sure the sensor switch and magnet is in a "closed"
position (if mounted, the gate or door should be closed).
Press and hold the Reset button on the back of the Indoor
2.
Alarm Receiver until all the LED indicators light up. This
resets the receiver.
Decide which channel (1, 2 or 3) you want to assign the
3.
Gate Sensor to, and then press and hold the desired
Channel button on the back of the Indoor Alarm Receiver
until the LED indicator for that channel lights up.
4. Within 10 seconds, trigger the Gate Sensor by separating
the sensor switch and magnet (if mounted, open the gate
or door). The Indoor Alarm Receiver sounds the channel
alarm and flashes the channel LED to confirm successful
pairing.
OPERATING BASICS
7