Operation - Ryobi RYi150C Operator's Manual

WARNING:
Risk of electric shock. When using a grounded appli-
ance, this tool will not provide an electrical path to earth
ground. Do not power devices with damaged or frayed
power cords.
WARNING:
If this product will be used only with cord and plug-
connected equipment, National Electric Code does not
require that the product be grounded. This product is not
suitable for any application that requires the product to
be grounded. Consult a qualified electrician, electrical
inspector, or local agency having jurisdiction for local
codes or ordinances to find out if grounding is needed
in your situation before using the product.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.

OPERATION

APPLICATIONS
You may use this product for the following purposes:
 For operating and charging USB-powered devices
 Supplying electrical power for operating compatible small
electronics such as cell phones, tablets, laptops, LED
lights, small fans, radios, etc.
 For charging a Ryobi 18V battery
NOTE: This device is not compatible for use with ap-
pliances, power tools, air conditioners, sump pumps,
compressors, and/or other larger electrical devices.
INSTALLING/REMOVING BATTERY PACK
See Figure 2.
 To install: insert a battery pack into the power source as
shown. Make sure the latches on the battery pack snap
into place and the battery pack is secured in the power
source before beginning operation.
 To remove: depress the latches on the battery pack.
USING THE POWER SOURCE
See Figure 3.
When a battery pack is installed, this power source converts
DC electricity to 120V AC household power and/or DC USB-
A or USB-C charging power, allowing the user to charge and
power a variety of devices.
The USB-dedicated charging ports will charge most USB-
compatible devices when used with the appropriate USB-A
fast charge (5V@3A, 9V@2A, 12V@1.5A DC) or USB-C PD
(5V@3A, 9V@3A, 12V@2.5A, 15V@2A, 20V@1.5A) cable. This
power source is also capable of charging an 18V battery
through the USB-C port. It does not charge and discharge
simultaneously.
WARNING:
Risk of electric shock. When using a grounded appli-
ance this tool will not provide an electrical path to earth
ground. Do not power devices with damaged or frayed
power cords.
6 — English