Advertisement
Warning
that the vibration emission during actual use of the power tool can differ from the declared total
value depending on the ways in which the tool is used; and
of the need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as
the times when the tool is switched off and when it is running idle in addition to the trigger time).
Wear hearing protection.
2.5 OPERATION
2.5.1 CHARGING THE BATTERY PACK
IMPORTANT: The battery pack is not fully charged at the factory. Before attempting to charge them,
thoroughly read all of the safety instructions.
1)
To assure that the charger you use are applicable to the battery pack.
2) Insert the charger into 220-240V~,50-60Hz outlet. The indicator light (13) become to red light to show
the power is connected.
3) Insert the battery(11) into the slot of charger(15). Make sure the contact with the charger is correct.
4) The indicator light (13) become to green and flash when charging.
5) When fully charged The indicator light (13) become to green light.
6) Frequently monitor the charger and battery pack while connected.
7) Unplug the charger and disconnect it from the battery pack when finished.
8) Allow the battery pack to cool completely before using it.
9) Store the charger and battery pack indoors, out of reach of children.
Note:
If the battery does not fit properly, disconnect it and confirm that the battery pack is the correct
model for this charger as shown on the specification chart. Do not charge any other battery pack
or any battery pack that does not securely fit the charger.
Note:
If battery is hot after continuous use in the tool, allow it to cool down to room temperature before
charging. This will extend the life of your batteries.
Note:
Remove battery pack from charger stand which use your thumb or fingers, press the battery's
release button in and pull the battery pack off at the same time.
2.5.2 BATTERY CAPACITY INDICATOR
There are battery capacity indicators on the battery pack; you can check the capacity status of the battery if
you squeeze the button . Before using the machine, please press switch trigger to check if the battery is full
enough for properly working.
Those 3 LED might show the status of the capacity level of the battery: Inserting and removing the
battery.
WARNING: Before making any adjustments ensure this tool is switched off with the direction
of rotation selector in the center position
Advertisement
