Advertisement
13) The indicator light (13) become to green and flash when charging.
14) When fully charged The indicator light (13) become to green light.
15) Frequently monitor the charger and battery pack while connected.
16) Unplug the charger and disconnect it from the battery pack when finished.
17) Allow the battery pack to cool completely before using it.
18) Store the charger and battery pack indoors, out of reach of children.
Note:
If the battery does not fit properly, disconnect it and confirm that the battery pack is the correct
model for this charger as shown on the specification chart. Do not charge any other battery pack
or any battery pack that does not securely fit the charger.
Note:
If battery is hot after continuous use in the tool, allow it to cool down to room temperature before
charging. This will extend the life of your batteries.
Note:
Remove battery pack from charger stand which use your thumb or fingers, press the battery's
release button in and pull the battery pack off at the same time.
3.7.2 BATTERY CAPACITY INDICATOR
There are battery capacity indicators on the battery pack; you can check the capacity status of the battery if
you squeeze the button . Before using the machine, please press switch trigger to check if the battery is full
enough for properly working.
Those 3 LED might show the status of the capacity level of the battery.
3.7.3 INSERTING AND REMOVING THE BATTERY
WARNING: Before making any adjustments ensure this tool is switched off with the direction
of rotation selector in the center position
1.
Remove the battery: press the battery release latch in and at the same time pull the battery pack off.
2.
To insert the battery, push the battery pack onto the contacts of the tool.
3.7.4 INSTALLING AND REMOVING A BIT AND A DRILL
This drill has a keyless chuck to prevent the bit or drill from loosening and allows you to hand tighten or
release drill bit in the chuck jaws
1. Turn ring A anticlockwise with the other hand until the drill chuck opening is large enough to accept the tool.
2. Insert the drill or the screwdriver bit into the drill chuck.
3. Turn ring A clockwise until the tool is clamped tightly.
4. Remove the tool in the opposite way.
3.7.5 SWITCH (4)
The drill is started and stopped by depressing and releasing the ON/OFF switch trigger.
3.7.6 SWITCH LOCK
The switch trigger can be locked in the center position.
Advertisement
