Table of Contents
Advertisement
Lens position setup and focus adjustment (continued)
z When using one of PT-FDZ97C / PT-FDW93C / PT-FDX110C
When moving the lens position to the lens standard position, perform the operation with
the following procedure.
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
3D SETTINGS
DISPLAY OPTION
PROJECTOR SETUP
P IN P
TEST PATTERN
SIGNAL LIST
SECURITY
NETWORK
MENU SELECT
SUB MENU
执行
PROJECTOR SETUP
STARTUP INPUT SELECT
RS-232C
STATUS
NO SIGNAL SHUT-OFF
REMOTE2 MODE
FUNCTION BUTTON
DATE AND TIME
LENS CALIBRATION
SAVE ALL USER DATA
LOAD ALL USER DATA
INITIALIZE
SERVICE PASSWORD
LENS
DLE030 POSITION
OK
执行
CANCEL
菜单
Note
z After returning the lens to the standard projection position, lens shift adjustments are
possible within the range where the projector will not interfere with the edges of the
projected image.
z If the rear of the projector blocks the bottom edge of the projected image, it may also
obscure the view of an On-screen display (OSD) that is positioned at the lower edge of the
screen. If this happens, open the [DISPLAY OPTIONS] menu and select [ON-SCREEN
DISPLAY] → [OSD POSITION] to change display location so that the whole OSD menu
can be seen.
2/2
LAST USED
SW1234567
ET-LAD120
DISABLE
DEFAULT
1.00
1.00
ACTIVATED
1) Turn on the projector to start the
projection.
2) Press the < 菜单 > button to dis-
play the [MAIN MENU] screen.
3) Select [PROJECTOR SETUP] in
the main menu and then press the
< 执行 > button.
4) Select [SERVICE PASSWORD] in
the [PROJECTOR SETUP] menu
and then press the < 执行 > button.
z The [SERVICE PASSWORD] input
screen appears.
5) Use the <0> and <3> numeric
buttons on the remote control to
enter "030" in the [SERVICE PASS-
WORD] input screen and then
press the < 执行 > button.
z The [DLE030 POSITION] screen
appears.
6) Press the < 执行 > button on the
[DLE030 POSITION] screen.
z [PROGRESS] is displayed on the
[DLE030 POSITION] screen and the
lens position moves to the standard
position for ET-DLE035C.
ENGLISH-11
Advertisement
Table of Contents
