Table of Contents
Advertisement
Pre-sailing
1
nstall the drain plugs – do not overtighten, hand tight is
I
sufficient. Overtightening may cause the drain plug
flange to distort and cause leakage.
3
Fit the daggerboards into the daggerboards wells. The
daggerboard roller shock cord should be tight enough
to prevent the daggerboard from slipping down.
2
Tension the rig. This can be accomplished by having
your assistant hang from the trapeze or you can use
mainsheet tension on one side at a time so that you
can adjust the shroud position in the side stay adjus-
ters.
4
It is recommended that beach rollers be used to move
your Hobie FX-One. This will save your back and the
bottom of the boat.
5
Always wash traveller and blocks with fresh water after
use in salty water.
Always wear your Hobie buoyancy vest,
look out for overhead power lines
22
Advertisement
Table of Contents
