AEG SANTO Z 9 18 44-4 i User Manual page 12

Open the appliance door and the fur-
niture door at 90°. Insert the small
square (Hb) into guide (Ha). Put
together the appliance door and the
furniture door and mark the holes as
indicated in the figure.
Remove the squares and drill holes
with ø 2 mm at 8 mm from the outer
edge of the door. Place the small
square on the guide again and fix it
with the screws supplied.
Should the lining up of the furniture
door be necessary, use the clearance
of slots.
At the end of operations, it is neces-
sary to check if the door of the fur-
niture closes properly.
Fix cover (Hd) on guide (Hb) until it
clips into place.
12
8mm
Hb
PR167
Hb
PR168
Hb
Hd
PR167/1
Ha