Mitsubishi Electric PEAD Series Service Manual page 4

SAFETY PRECAUTION
Gravimeter
<3> Service tools
Use the below service tools as exclusive tools for R410A refrigerant.
No. Tool name
1 Gauge manifold
2 Charge hose
3 Electronic scale
4 Gas leak detector
5 Adaptor for reverse flow check
6 Refrigerant charge base
7 Refrigerant cylinder
8 Refrigerant recovery equipment
1-3. CAUTIONS RERATED TO HEATER
• Exercise caution when using any auxiliary heat source and follow all third party manufacturer instructions and safety
guidelines for installation and usage.
• Any auxiliary heat source connected to this unit via the CN24 connection must have an independent temperature control
mechanism. Failure to install and maintain such temperature control mechanism may void the warranty for this unit.
• Mitsubishi Electric shall not bear any warranty obligation or other liability for any damage or loss in connection with such third
party auxiliary heaters.
HWE2109A
Specifications
• Only for R410A
• Use the existing fitting specifications. (UNF1/2)
• Use high-tension side pressure of 5.3MPa·G or over.
• Only for R410A
• Use pressure performance of 5.09MPa·G or over.
• Use the detector for R134a, R407C or R410A.
• Attach on vacuum pump.
• Only for R410A
• Top of cylinder (Pink)
• Cylinder with syphon
4
Unit
—
—
—