Danfoss TFX Installation And Operation Manual page 51

The LED on the D-Sub connector (CAN1) lights
up red.
3. Wait until both LEDs on the device light up orange.
4. Slide the switch on the D-Sub connector (CAN1)
toward the LED.
NOTICE
Device defect due to power failure.
Repair by supplier is necessary if there is a destroyed le
system on the device.
Do not disconnect the device from the power supply until
•
the process has been completed.
TFX INSTALLATION AND OPERATION MANUAL
The device reverts to the rmware defaults (object
0x1011 0x65).
The ON LED lights up green.
The STATUS LED lights up blue.
The device has adopted the rmware defaults (baud
rate 250 kbit/s, node ID 39 etc.).
INFORMATION
You can restore the factory con guration of the device using
object 0x1011, sub-index 0x01.
INFORMATION
For more information on the LED status indicators, see
chapter Indicator elements (LED).
See the Service and support section for
additional assistance.
6046279-001 March 2020
Operation
45